Epson 440 User Manual download pdf (Page 136)

EPSON Stylus Color 440/640/740 Revision A

Chapter 5 Adjustment 136

5.2.2.2 Entering the Main menu

Before performing any adjustment, you need to enter the main menu,

however, you may have to take the following extra steps before entering

the main menu depending on the printer model name and mode name

registration status.

Registering the model name (Section 5.2.2.2.1.)

Setting the CG (Section 5.2.2.2.2.)

Therefore, read the instructions carefully and take the appropriate

steps.

Connect the printer and PC and turn on the printer.

Insert the disk for the adjustment program to the floppy disk drive.

Type SC440, SC640, or SC740 on the DOS or DOS prompt.

Type the exclusive program name* SC440.EXE, SC640.EXE, or

SC740.EXE on the DOS prompt.

* The adjustment program name provided with each printer is shown

below.

Following screen appears.

Figure 5-6. Initial Screen (1)

A(In case of FD):\SC440.EXE for Stylus Color 440

A(In case of FD):\SC640.EXE for Stylus Color 640

A(In case of FD):\SC740.EXE for Stylus Color 740

If the printer’s model name has been registered, go to

Step 5.

[For Stylus Color 740]

If your printer is Stylus Color 740, you must set the

correct CG, NLSP or Standard. Therefore, be sure to

read the instructions in the following step carefully to

take the proper steps

If no model name is registered, go to Section 5.2.2.2.1 /

Step 1.

M S-D O S Prom pt-S C 640

Auto

Starting the service program .

C hecking the m odel nam e now .

Note:

This screen is com m on for Stylus C olor 440, 640,

and 740 except for the program nam e.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 211 212

No comments

Epson 440 User Manual Page 136