Epson H6000IIP - TM Two-color Thermal Line User Manual download pdf (Page 10)

8 TM-H6000II User’s Manual

English

1. Wait until the SLIP light flashes. Then insert the check face up

with the right side of the check against the right side of the

paper guide as far as it will go. Be sure that the MICR

characters are on the right.

2. The printer will detect the check and start drawing it in. When

the printer starts drawing it in, let go of the check immediately.

When the printer ejects the check and the SLIP light starts

flashing again; remove the check by pulling it straight up; do

not pull it at an angle.

Cleaning the MICR Mechanism

Approximately every 12 months clean the MICR head with a

moistened cleaning sheet.

Use the following or an equivalent commercially available cleaning

sheet:

PRESAT brand (KIC) “CHECK READER CLEANING CARD.”

Note:

Be sure not to use an adhesive cleaning sheet.

Follow the steps below:

1. Load a paper roll in the printer; turn off the power; then open

the paper roll cover and turn the power back on while holding

down the RELEASE button.

MICR

characters

on this side

face up

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

No comments

Epson H6000IIP - TM Two-color Thermal Line User Manual Page 10