Epson Perfection 610 Scanner Basic Guide download pdf (Page 15)

Connect the Scanner to Your Computer

If you are connecting to a PC, Windows 98 must be preinstalled on your system.

1. Make sure the scanner is unplugged, and the computer and any USB devices

connected to your computer are turned off.

2. Locate the USB cable that came with your scanner.

3. Plug the square connector on the USB cable into the USB connector

on the back of the scanner. Then plug the flat connector into the USB

port on your computer or USB hub.

Your system may not work correctly if you use a USB cable

other than the one supplied by EPSON or if you connect your

scanner through more than one hub.

Power On Your System

Plug in your scanner before you turn on the computer. Otherwise, the computer may

not recognize your EPSON scanner when you install your software. (The scanner

lamp turns on when it is plugged in, but goes into sleep mode when it has not been

used for ten minutes. The lamp comes back on when you scan.)

It is recommended that you unplug your scanner when you are

not using it.

basics.book Page 10 Wednesday, August 11, 1999 2:26 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

No comments

Epson Perfection 610 Scanner Basic Guide Page 15