Epson CX3800 Service Manual Page 123

  • Download
  • Add to my manuals
  • Print
  • Page
    / 171
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 122
EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
DISASSEMBLY/ASSEMBLY Printer Section 123
External view (3)
Figure 4-35. Removing Carriage Unit (3)
CR Encoder Removal
1. Disconnect the Head FFC from the connector of the CR Encoder Board, and
pull out the Head FFC from the notch of Carriage.
2. Rem
ove the screws (x2, ) that secure the CR Encoder Board, and remove
the CR Encoder Board
Head FFC Removal
1. Remove the Printhead from the Carriage Unit.
2. Pull
out the Head FFC from the notch of the Carriage.
3. Release the Head FFC from the tabs (x4, ) that secure the Head FFC.
4. Dis
connect the Head FFC from the connector of the CSIC board.
Tabs
Notch
CR Encoder Board Connector
C.P.B. (P1)1.7x5, F/ZB
(0.5kgfcm)
Notch
Head FFC
Guide Pins
Connector
Match the guide pins of the Carriage (x2, ) with the positioning
hole (x2) of the CR Encoder Board.
A D J U S T M E N T
R E Q U I R E D
After replacing the Carriage Unit with a new one, always apply
grease KEN to the specified parts.
Refer to Figure 6-7 (p152)and Figure 6-8 (p152) for details.
After replacing the Carriage Unit,
perform the adjustment in
the following order. (Refer to Chapter 5 “ADJUSTMENT”)
1. “PG Adjustment”
2. “Top Marg
in Adjustment”
3. “H
ead Angular Adjustment”
4. “Bi-D Adjustment”
5. “First Dot Adjustment”
Page view 122
1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 170 171

Comments to this Manuals

No comments