Epson AcuLaser C9300 User Manual download pdf (Page 79)

Chapter 5

Tips for Administrator

Setting an IP Address on the Printer’s Control Panel

After connecting the printer to the network, you need to set the IP address for the network interface.

To set the IP address, subnet mask, and default gateway from the control panel, follow the steps below.

Note:

If you are using a printer model that does not have an LCD panel, you cannot use the steps below.

1. Turn on your printer.

2. Press the Right button on the printer’s control panel once to enter the SelecType mode. The LCD

panel displays Information Menu.

3. Press the Up or Down button until Network Menu appears. Then press the Right button.

4. Check that Network I/F = On appears.

If Network I/F = Off appears instead, press the Right button and then the Up or Down button

to change to Network I/F = On. Then press the Right button, turn off the printer for more than

five seconds, and turn it back on.

5. Press the Up or Down button until Get IP Address = Auto appears. Press the Right button

and then the Up or Down button to change to Get IP Address = Panel. Then press the Right

button. You can use the following methods to get an IP address.

❏ Choose Panel when setting the IP address, subnet mask, and default gateway using the

printer’s control panel.

❏ Choose Auto when getting the IP address from a DHCP server. The IP address is automatically

obtained from the DHCP server whenever the printer is reset or turned on.

❏ Choose PING when setting the IP address using the arp/ping command. The network interface

uses the IP address set by the arp/ping command. The settings become available when the

printer is reset or turned off and then back on.

Epson Network Guide

Tips for Administrator 79

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 91 92

No comments

Epson AcuLaser C9300 User Manual Page 79