Epson 9000i - PowerLite SXGA LCD Projector Owner's Manual download pdf (Page 51)

Connecting to a Computer

■ ■ ■ ■ ■

■

4. Connect the other plugs on the audio/video cable to the

Audio jacks of the projector: insert the white plug into the

L jack and the red plug into the R jack. Connect the plug

at the other end of the audio/video cable to the audio

output jacks of the video source.

5. For S-Video, insert one end of an S-Video cable into the

projector’s S-Video connector. Insert the other end into

the S-video-out jack of your video source.

6. For component, insert three ends of a BNC cable into the

projector’s R/R-Y, G/Y and B/B-Y jacks. Insert the

opposite ends of the cable into the Y/Video, C/R-Y, and

B-Y jacks on your component video source. (Don’t insert

any of the cable ends into the HD/Sync and VD jacks.)

7. Make sure the Computer 2/BNC switch is set to BNC.

♦

Note:

When the Computer 2/BNC switch is set to BNC, the

projector is unable to project the Computer 2 image signal.

♦

Note:

Use a standard BNC cable, which you can purchase from

any computer store. The 5BNC video cable supplied by EPSON

as an optional accessory does not work with component video.

S-Video connector

S-Video cable

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 127 128

No comments

Epson 9000i - PowerLite SXGA LCD Projector Owner's Manual Page 51