Epson ELPLP29 User Manual download pdf (Page 49)

Troubleshooting > When You Suspect a Problem

f Image is out of focus (unclear)

• The image is

fuzzy

• Part of the

image is out of

focus

• The whole

image is out of

focus

• Have the "Sync.g", "Trackingg" and

"Position" settings been adjusted correctly?

If the configuration menu "Image" → "Auto Setup" setting has been set to

"OFF", press the [Auto] button on the remote control to adjust these

settings. If the images have not been correctly adjusted after pressing the

[Auto] button and using the auto setup function, adjust the settings

manually in their respective menus. ([Menu] button → "Image" → "Picture

Quality" → "Tracking", "Image" → "Picture Quality" → "Sync.", "Setting" →

"Screen" → "Position") s "Image menu" P.35 , "Setting menu" P.38

• Are the image signal format settings

correct?

• When a computer or Component Videog equipment is connected, select

the appropriate setting for the input source you are using, in the "Image"

→ "Input Signal" configuration menu.

• When Composite Videog or S-Videog equipment is connected, select

the appropriate setting for the video system you are using in the

"Setting" → "Video Signal." configuration menu.

• Is the projector positioned at right angles to

the screen?

s "Installation method" P.10

• Is the projector at the correct distance from

the screen?

The optimum range for projection is 87-1109cm (2.9-36.4ft.). Set the

projector within this range. s "Installation method" P.10

• Are the front feet set so that the image

angle is too big for the screen?

If the image angle is too big the image will be out of focus vertically.

s "Adjusting the projection angle" P.24

• Is the lens dirty?

s "Cleaning the lens" P.54

• Has condensation formed on the lens?

If the projector is suddenly taken from a cold environment to a warm

environment, condensation may form on the surface of the lens, and this

may cause the images to appear fuzzy. Set the projector up in the room in

which it is to be used approximately one hour before use. If condensation

forms on the lens, turn off the power and wait for the condensation to

disappear.

• Has the focus been correctly adjusted?

s "Adjusting the Display" P.23

• Is the lens cover still in place?

s "Turning on the Projector" P.20

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 74 75

Comments to this Manuals

No comments

Epson ELPLP29 User Manual Page 49

Comments to this Manuals

Related products and manuals for Data projectors Epson ELPLP29