Epson C11C560031BS Datasheet download pdf (Page 31)

Chapter3 PaperHandling 31

Adjusting the top-of-form position

The top-of-form position is the vertical position on the page where

the printer starts printing. If the printout appears too high or low

on the page, you can use this function to adjust the top-of-form

position.

Follow these steps to adjust the top-of-form position:

Note:

❏ The factory set default for the top-of-form position is set as shown

below.

PR2: 4.2 mm

ESC/P and IBM PPDS: 8.5 mm

❏ This mode can be used even when the printer cover is open.

❏ If you wish to change the top-of-form position in PR40+, make sure

that you set the TOF position for PR40+ to Off.

❏ Your top-of-form position setting remains in effect until you change

it, even if you turn off the printer.

❏ The top margin setting made in some application software overrides

the top-of-form position setting you make with this function. If

necessary, adjust the top-of-form position in your software.

❏ Prepare an A4 size sheet of paper before using this function.

1. Turn off the printer.

Caution:

Whenever you turn off the printer, wait at least five seconds

before turning it back on; otherwise you may damage the

printer.

2. Turn on the printer while holding the F2 button.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 175 176

No comments

Epson C11C560031BS Datasheet Page 31