Epson NX100 Quick Start Guide download pdf (Page 3)

Epson Stylus

NX100 Series

Start Here

6 Release the scanner support and lower the scanner.

7 Press the Stop button to charge the ink. Charging takes about

2 minutes.

Caution: Don’t turn off the NX100 Series while it is charging or you’ll

waste ink.

Unpack

If anything is missing, contact Epson as described on the back.

Caution: Do not open the ink cartridge package until you are ready to install

the ink. Cartridges are vacuum packed to maintain reliability.

Canada only: For French speakers, remove stickers from the backing sheet

and place over corresponding text on the control panel.

Remove all the tape.

Stop

3 Flip the feeder guard forward. Then squeeze the edge guide and

slide it left.

4 Load paper against the right edge and underneath the tab, then slide

the edge guide over.

Note: Don’t load the paper sideways.

5 Flip the feeder guard back.

4114365 Rev.0

1-F C

4114365 Rev.0

1-F M

4114365 Rev.0

1-F Y

4114365 Rev.0

1-F K

Turn on the NX100 Series

1 Connect the power cable.

Note: Do not connect to the computer at this time.

2 Press the On button.

Load paper

1 Open the paper support.

2 Open the output tray and pull out the extension.

8½ 11

4 6

Install cartridges

Note: Do not load paper yet.

1 Lift up the scanner and prop it up with the support.

2 Shake the ink cartridges, then unpack them.

3 Remove only the yellow tape from each cartridge.

Caution: Do not remove any other seals or the cartridge may leak.

4 Insert the cartridges in the holder for each color.

5 Press each cartridge down until it clicks.

(Included for Canada only)

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Epson NX100 Quick Start Guide Page 3

Comments to this Manuals

Related products and manuals for Multifunctionals Epson NX100