Epson ExpressStation User's Guide Page 59

  • Download
  • Add to my manuals
  • Print
  • Page
    / 118
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 58
2.
Position the hard disk drive so its mounting screw holes face
upward and the drive and power supply connectors face
into the drive housing. Then slide the drive into the
housing.
SCSI drive
connector
3.
Secure the drive to the housing with the four screws that
came with the drive. If you are installing a third-height
drive, you need to lift up the drive to install the screws by
hand. Then tighten them with a screwdriver.
4.
Plug the drive into the appropriate interface, as shown in the
illustration above. (The IDE drive interface is beneath the
SCSI drive cable.) Then plug in the power cable. Be sure
that you plug the connectors all the way into their sockets.
5.
Replace the drive housing and cover as described in
Chapter 2; then follow the “Post-installation Setup
Procedures” at the end of this chapter to update your
configuration.
3-20 Installing and Removing Options
Page view 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 117 118

Comments to this Manuals

No comments