Epson ExpressStation User's Guide Page 62

  • Download
  • Add to my manuals
  • Print
  • Page
    / 118
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 61
Chapter 4
Using the SCSI Subsystem
This chapter describes the basic operations you need to perform
to use the computer’s built-in SCSI-II subsystem. The SCSI-II
subsystem consists of the following components:
Cl
SCSI controller for single-ended SCSI devices
LI
Internal SCSI hard disk drive connector
U
External SCSI device port
t2
External SCSI device terminator.
Your system also comes with SCSI drivers for MS-DOS. You
may need to install these drivers after you have installed your
SCSI devices, depending on how you configure the subsystem.
See the Software Guide for instructions on installing and using
the drivers.
To set up your SCSI subsystem, you need to do the following:
U
Set SCSI ID numbers for all of your SCSI devices
U
Install a SCSI terminator on the last external SCSI device
Ll
Install or connect the internal and/or external SCSI devices
tl
Format and partition any SCSI hard disk drives
Ll
Install the operating system(s) on a SCSI hard disk drive
(if you will boot your system from a SCSI drive)
D
Install and configure any necessary SCSI device drivers.
These operations are described in this chapter.
Using the SCSI Subsystem
4-1
Page view 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 117 118

Comments to this Manuals

No comments