Epson ExpressStation User's Guide download pdf (Page 63)

Note

If you plan to use a SCSI hard disk drive as the drive from

which you load your operating system, be sure you set the

following options when you configured your system:

Enable the built-in SCSI controller

Disable the built-in IDE hard disk drive controller

Set both hard disk drive types to Not installed.

See your

Software Guide

for instructions on running either the

BIOS SETUP program or the System Configuration utility to

check these options.

Setting the SCSI ID Numbers

Each SCSI device must have a SCSI ID number, from 0 to 7;

including the computer’s SCSI built-in controller. The controller

is automatically set to ID number 0. You must manually assign

a SCSI ID number for each of your SCSI devices.

The system automatically boots from the SCSI device with the

lowest ID number, so keep this in mind as you set the ID

numbers for your devices.

To assign the ID number for most SCSI devices, you set

jumpers or switches on the device. See the manual that came

with each device for instructions on setting its jumpers or

switches.

4-2

Using the SCSI Subsystem

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 117 118

No comments

Epson ExpressStation User's Guide Page 63