Epson TM-H6000IV User Manual download pdf (Page 19)

TM-H6000IV-DT User’s Manual 19

English

Loading/Replacing the Roll Paper

Follow the steps below to load/replace the roll paper.

CAUTION:

Be sure to use the specified roll paper.

1. Open the roll paper cover. (See “Roll paper cover” on page 17.)

2. Remove the used roll paper core, if there is one.

3. Insert the roll paper in the correct direction. See Illustration O.

4. Pull out some paper, and close the roll paper cover.

5. Tear off the paper with the cutter. See Illustration P.

Inserting the Slip Paper

When printing on the slip paper, follow the steps below to insert the slip paper.

MICR reading is available by inserting the paper so that the MICR characters on the

paper are on the right side.

CAUTION:

❏

Do not insert any paper that has clips or staples. This may cause paper jams and

damage.

❏

Make sure the slip paper is flat, without curls, folds, or wrinkles.

❏

For MICR reading, use the slip paper of 12 cm {4.72”} long or more.

1. Turn on the product. (See “Turning Power On/Off” on page 17.)

2. Insert the slip paper face up with the right paper edge against the right side of the

paper guide, and insert it as far as it will go. See Illustration Q.

3. Insert the paper straight until the top edge of the paper touches the stopper. See

Illustration R.

4. When the product starts feeding the paper, release it immediately.

5. Remove the ejected paper by pulling it straight up out of the product. See

Illustration S.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 83 84

No comments

Epson TM-H6000IV User Manual Page 19