Epson TM-H6000IV User Manual download pdf (Page 20)

20 TM-H6000IV-DT User’s Manual

English

Cleaning

Cleaning the Product Case

Be sure to turn off the product, and wipe the dirt off the product case with a dry cloth

or a damp cloth.

CAUTION:

Never clean the product with alcohol, benzine, thinner, or other such solvents. Doing

so may damage or break the parts made of plastic and rubber.

Cleaning the Thermal Head

To maintain receipt print quality, Epson recommends cleaning the thermal head

periodically (generally every 3 months) by following the steps below.

CAUTION:

❏

The thermal head can be very hot after printing. Be careful not to touch it and to let

it cool before you clean it.

❏

Do not damage the thermal head by touching it with your fingers or any hard

object.

1. Turn off the product. (See “Turning Power On/Off” on page 17.)

2. Open the roll paper cover. (See “Roll paper cover” on page 17.)

3. Clean the thermal elements of the thermal head with a cotton swab moistened

with an alcohol solvent (ethanol or IPA). See Illustration T.

Cleaning the MICR Head

Approximately every year, clean the MICR head by following the steps below. When

the MICR head becomes dirty, the product cannot read MICR characters normally.

Use the following or an equivalent commercially available cleaning sheet:

KIC Products "Waffletechnology® MICR cleaning card"

CAUTION:

❏

Be sure not to use an adhesive cleaning sheet.

❏

Be sure that the cleaning sheet is inserted with the correct side up and in the correct

direction.

❏

Use a cleaning sheet only one time; then discard it.

1. Make sure the roll paper is installed correctly and the product is turned off.

2. Open the roll paper cover. (See “Roll paper cover” on page 17.)

3. While holding down the release button, turn the power back on.

4. Press the release button 7 times; then close the roll paper cover.

5. After the product prints “***RECOGNITION MODE*** Please set check.” on the

roll paper and the slip LED flashes, insert the cleaning sheet like standard slip

paper. (See “Inserting the Slip Paper” on page 19.)

6. Remove the ejected paper by pulling it straight up out of the product.

7. Turn off the product to exit the cleaning mode.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 83 84

Comments to this Manuals

No comments

Epson TM-H6000IV User Manual Page 20

Comments to this Manuals

Related products and manuals for POS/mobile printers Epson TM-H6000IV