Epson EMP-82 User's Guide download pdf (Page 29)

Security functions

Turn "Password Timer" on.

If you don't use this setting, proceed to step 4.

(1) Select "Password Timer", and then press the [Enter]

button.

(2) Select "On", and then press the [Enter] button.

(3) Press the [Esc] button.

(4) Select "Timer" and then press the [Enter] button.

(5) While holding down the [Num] button, use the numeric

keypad buttons to enter the setting time within the range of

1 to 9999 hours and then press the [Enter] button.

If you make a mistake entering the time, press the [Esc]

button and re-enter the time.

When you have finished using the "Password Protect"

menu, the countdown for the elapsed time will start.

Turn "User’s Logo Protect" on.

(1) Select "User’s Logo Protect", and then press the [Enter]

button.

(2) Select "On", and then press the [Enter] button.

(3) Press the [Esc] button.

Enter the password.

(1) To set a password, select "Password" and then press the

[Enter] button.

(2) The message "Change the password?" will be displayed,

so select "Yes" and then press the [Enter] button. The

default setting for the password is "0000", but you should

change this to your own desired password. If you select

"No", the screen shown at step 1 will be displayed again.

(3) While holding down the [Num] button, use the numeric

keypad buttons to enter a 4-digit number. The number

entered will be displayed as "* * * *". Once four digits

have been entered, the confirmation screen will be

displayed.

(4) Re-enter the password.

The message "The new password is stored." will be

displayed. If you enter the password incorrectly, a message

will be displayed prompting you to re-enter the password.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 79 80

No comments

Epson EMP-82 User's Guide Page 29