Epson Panamorph Anamorphic Lens Kit Owner's Manual download pdf (Page 11)

ATH2 Owner’s Manual

8 Rear Panel –Triggers

To use the automatic lens trigger, with a projector or scaler equipped with an external 12V lens trigger, use

a standard double-ended 3.5 mm (1/8 inch) male mono or stereo jack cable. Simply plug the cable into the

projector or scaler lens trigger jack, and then into the ATH2 +12V Trigger In jack. Follow projector or

scaler instructions to configure the lens trigger to send the lens in when the vertical strectch aspect ratio is

selected on the projector. Any voltage change (12V to 0V, 0V to 12V) will automatically turn the sled on

causing it to move to the designated position. When using the trigger, the remote control is not required

after configuration.

NOTE: Plugging a live trigger in will automatically turn the sled on and cause it to move. Stand clear of

the lens path when inserting the trigger cable.

The

Trigger In (tip positive) operates as follows:

+12V LENS IN

0V LENSOUT

NOTE: The input trigger jack may be temporarily overridden by the remote control. When the next

change of voltage at the trigger occurs (up or down), the projector or scaler will take control of the sled.

Optionally, you may use the +12V Trigger Out jack on the rear of the device to control motorized screen

masking. The output jack is toggled to +12V whenever the sled is in the LENS OUT position. The output

trigger voltage is toggled when the lens begins traversal so that masking and lens movement may be

overlapped. Maximum output current is 100mA which is sufficient for most masking screen control

modules. The sled is configured to trigger the masking in when the lens it out, so the signal is opposite the

input trigger.

The

Trigger Out jack (tip positive) is intended to for use with external masking screens, It operates as

follows:

+ 0V Lens is moving to, or is in the LENS IN position. Note this is the inverse of the input signal.

+12V Lens is moving to, or is in the LENSOUT position. Note this is the inverse of the input signal.

The equipment control port is used by OEM projector manufacturers for custom control options. It can be

ignored by installers.

+9v to +12v In

+12v Trigger Out

+12v Trigger In

To screen

masking

controller, max

Auxiliary In

From

projector or

scaler trigger,

min 3.5uA

OEM equipment

control

ort

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Epson Panamorph Anamorphic Lens Kit Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Projectors Epson Panamorph Anamorphic Lens Kit