Epson Panamorph Anamorphic Lens Kit Owner's Manual download pdf (Page 5)

ATH2 Owner’s Manual

3 Plan your installation

The lens assembly may be mounted in one of two ways:

1) To the ceiling or projector mount above the projector

2) To a shelf or table below the projector

When attaching motor assembly to the ceiling, use a board, plate, or lens enabled projector mount

attached to the ceiling joists or studs. Sheetrock embedded fasteners will work loose with repeated lens

movement causing the mechanism to fall, resulting in possible severe injury. The Panamorph AKX or

AKCPro mounting kit is highly recommended.

Changing Orientation of Logo Plate (optional)

As shipped, the lens sled is configured for ceiling mounted operation. As such, the logo reads right side up

with the mounting bar on top. If you are using the sled in a table or shelf mounted configuration, you may

optionally turn the logo around so that it is right side up with the mounting bar below the projector.

To reverse the logo, remove the 4 screws securing the motor housing cover. Lightly spread the sheet metal

cover and lift it off. Once removed, you can easily access the logo plate. Remove the two small plastic

screws securing the logo plate, turn the plate around, and re-install the screws. Lightly tighten the screws,

as the threads are plastic. Re-install the motor cover housing using the original screws. Make sure the fiber

optic light pipe connector is completely inside the housing before reinstalling motor housing screws.

An alternative to reversing the logo plate is to turn off the back light, thereby rendering the logo

inconspicuous. Simply press the PANEL OFF button to accomplish this.

4) Reinstall 4

cover screws

1) Remove 4

cover screws

and remove

cover

3) Turn plate

around replace 2

logo plate screws

2) Remove 2

logo plate screws

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Epson Panamorph Anamorphic Lens Kit Owner's Manual Page 5