Setting the Main System Board Jumpers
The illustration below shows the locations of jumpers JP1, JP3,
JP5, JP8, JP9, and JP10 on the main system board. Check the
table earlier in this appendix to see which one(s) you need to
change.
To move a jumper from one position to the other, use your
fingers or needle-nose pliers or tweezers to pull it off its current
pins and gently move it to the other position. Be careful not to
lose the jumper or leave it out of the computer. Also take care
not to damage any surrounding components on the main system
board.
Changing Jumper and DIP Switch Settings
A-13
Comments to this Manuals