Epson Equity 386/25 User Manual download pdf (Page 183)

If you are running an application program, see “Software

Problems,” later in this appendix. This section covers

certain problems caused by application programs.

If you want to stop whatever the computer is doing and

return to the MS-DOS command prompt, hold down the

Ctrl key and press Break. In most cases, this solves the

problem. See Chapter 3 for more information on stopping a

command or program.

If your computer still does not respond, you can reset it with

the RESET button. Follow the instructions in Chapter 3.

If resetting the computer does not work, turn off the

computer, wait at least five seconds, and turn it on again.

If you do not have a hard disk drive, insert the Startup

diskette in drive A. The computer should load MS-DOS.

Password Problems

If you set a power-on password using the Setup program, you

must enter this password after you turn on your computer before

you can use the system. When you turn on the computer, the

screen displays a key prompt ( ). If you do not enter the

correct password, you see an x on the screen to indicate it is

incorrect. The computer gives you a second and third chance to

enter it correctly.

If after three tries you have not entered the correct password,

the computer locks up and does not respond to your keyboard

entries.

B-4

Troubleshooting

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 295 296

No comments

Epson Equity 386/25 User Manual Page 183