Epson Software Film Factory v3.0 User's Guide download pdf (Page 18)

Page 18

Modifying the conﬁguration

You should edit the conﬁguration whenever there is any change that would affect your

original conﬁguration, such as a change in IP address. First change the speciﬁc RIP Station

Setup information before conﬁguring the connection.

TO MODIFY THE CONFIGURATION:

1. To edit information for a RIP Station in the list of available servers, select the RIP Station

by its nickname and click Modify. Edit information in the Modify Server Settings dialog box

as necessary, and click OK when ﬁnished.

2. To add a new RIP Station to the list of available servers, click Add. Conﬁgure the Add New

Server dialog box as outlined in step 3 through step 5 above.

3. To remove a RIP Station from the list of available servers, select the RIP Station by its

nickname and click Remove.

Fiery WebTools

In order for network users to access and use Fiery WebTools, you need to set certain

RIP Station options in Setup. The names of these options have changed since version 1.1.

TO VERIFY THAT FIERY WEBTOOLS ARE SET UP ON THE RIP STATION:

1. Print the Conﬁguration page from the RIP Station Control Panel.

For Instructions see the User Guide.

2. On the Conﬁguration page, check the following:

• In NetworkSetup>Port Setup>Ethernet Setup, conﬁrm that “Enable Ethernet” is set to

Yes.

• In Network Setup>Protocol Setup>TCP/IP Setup, conﬁrm that TCP/IP is enabled and

that there is a valid, unique IP Address for the RIP Station.

• In Network Setup>Service Setup, conﬁrm that Web Services are enabled.

3. If all the conditions listed in step 2 are currently set, the RIP Station is properly set up to

use Fiery WebTools.

If any of the conditions listed in step 2 are not currently set, you must change them (as

described in the Administrator Guide) before you can use Fiery WebTools.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

No comments

Epson Software Film Factory v3.0 User's Guide Page 18