Epson EB-4750W User's Guide download pdf (Page 19)

• An optional ceiling mount is required when suspending the

projector from a ceiling.

s "Optional Accessories" p.137

• The default Projection setting is Front. You can change from Front

to Rear from the Configuration menu.

s Extended - Projection p.78

• You can change the Projection mode as follows by pressing down

the [A/V Mute] button on the remote control for about five seconds.

FrontWFront/Ceiling

RearWRear/Ceiling

• When mounted on a ceiling, set Inv Direction Button to On so that

the operations and movement of the [

], [ ], [ ], and [ ]

buttons on the control panel match.

s Extended - Operation - Inv Direction Button p.78

The projector can be installed at the following angles.

Vertical: Tilt up to ±30°. If you use the projector tilted at an angle of more

than 30° it could be damaged and cause an accident.

Horizontal: Can be tilted within the range of expansion and contraction for

the rear feet.

s "Adjusting the Horizontal Tilt" p.24

Make sure there is a gap of at least 50 cm between the wall and the air

exhaust vent and the air intake vent.

Air exhaust vent

Air intake vent

When setting up multiple projectors, make sure there is a gap of at least

50 cm between the projectors.

Screen Settings

Set the Screen Type according to the aspect ratio of the screen being used.

The area where the image is displayed matches the shape of the screen.

Press the [Menu] button while projecting.

s "Using the Configuration Menu" p.71

Select Display from Extended.

Installing the Projector

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 155 156

No comments

Epson EB-4750W User's Guide Page 19