Epson EB-4750W User's Guide download pdf (Page 39)

Switching to the Target Image by Remote Control

You can change directly to the target image by pressing the following

buttons on the remote control.

The input ports for each button are shown below.

Remote control

Input Port

Changes to images from a computer connected via the network. See the following

section to check the position of the LAN port.

s "Interface" p.9

Adjusting the Volume

You can adjust the volume using one of the following methods.

• Press the [Volume] button on the remote control to adjust the volume.

[

a] Decreases the volume.

[

b] Increases the volume.

Remote control

• Adjust the volume from the Configuration menu.

s Settings - Volume p.77

Caution

Do not start at high volume.

A sudden excessive volume may cause loss of hearing. Always lower the volume

before powering off, so that you can power on and then gradually increase the

volume.

Projecting Images

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 155 156

No comments

Epson EB-4750W User's Guide Page 39