Epson EMP-730 User Manual download pdf (Page 78)

Caution :

• If the lamp stops working and needs to be replaced, there is the danger that the lamp

may break when handled.

If replacing the lamp of a projector that has been installed to the ceiling, you should

always assume that the lamp is broken and remove the lamp cover very carefully.

• Wait until the lamp has cooled down sufficiently before opening the lamp cover. It takes

a further one hour after the cool-down

period has finished for the lamp to be cool

enough.

Procedure

Turn off the projector power, wait

for the cool-down period to end,

and then disconnect the power

cable.

The cool-down period lasts for about 45

seconds. The actual time will vary

depending on the external air temperature.

Wait until the lamp has cooled

down, and then remove the lamp

cover from the base of the

projector.

It takes approximately one hour for the

lamp to cool down by itself after the cool-

down period has finished.

While pressing the two hooks, pull the

lamp cover up to remove it.

Loosen the two lamp fixing screws.

Use the screwdriver that is supplied with

the spare lamp or a Phillips screwdriver to

loosen the two lamp fixing screws that are

securing the lamp to the projector.

Replacing the Lamp

Maintenance

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 99 100

No comments

Epson EMP-730 User Manual Page 78