Epson ActionTower 8600 User's Guide Page 97
- Page / 183
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
4.
Position the IDE device cable so the side with the red wire
aligns with pin 1 on the drive. Make sure the holes in the
connector fit over all the pins; then push in the connector.
power supply
’
IDE device
cable
5.
Locate one of the power supply cables that lead from the
power supply. (They have multicolored wires and a plastic
connector on the end.) Align the notched corners of the
power supply connector and the drive’s power connector;
then push in the connector, as shown above.
Note
Your system has five power supply cables; three with large
connectors and two with small connectors. If you need more
than five cables, you can purchase Y-adapters at most
computer accessory stores. Y-adapters let you use one power
supply cable for two devices.
6.
If you have finished installing or removing drives, replace
the computer’s cover; see “Replacing the Cover” in
Chapter 3 for instructions. Then see “Running SETUP” in
Appendix B for instructions on defining your new drive
configuration.
5-6 Installing and Removing Tower Drives
- User’s Guide 1
- IMPORTANT NOTICE 2
- DISCLAIMER OF WARRANTY 2
- COPYRIGHT NOTICE 2
- TRADEMARKS 2
- Important Safety Instructions 3
- Importantes 4
- Contents 7
- Troubleshooting 9
- Specifications 9
- 10
- Introduction 11
- Power-saving Feature 12
- ISA and PCI Expansion Buses 13
- System and Video BIOS 13
- Plug and Play Compatibility 14
- MPEG Video Playback Support 14
- BIOS Upgrades 14
- How to Use This Manual 15
- Where to Get Help 16
- Electronic Support Services 17
- 8 Introduction 18
- Chapter 1 19
- 1-2 Setting Up Your System 20
- Connecting System Components 21
- Connecting a Monitor 22
- Setting Up Your System 1-5 23
- 1-6 Setting 24
- Your System 24
- Using the serial ports 25
- Setting Up Your System 1-7 25
- Turning On the Computer 26
- Setting Up Your System 1-9 27
- Turning Off the Computer 28
- Chapter 2 29
- Using the Right Furniture 30
- Positioning Your Monitor 31
- Lighting Your Workspace 31
- Using the Keyboard and Mouse 32
- Using Energy Wisely 33
- Using Your Green PC Feature 34
- Using Your Computer 2-7 35
- 2-8 Using Your Computer 36
- Stopping a Command or Program 37
- Resetting the Computer 38
- Using a Password 38
- Using Your Computer 2-11 39
- 2-12 Using Your Computer 40
- Chapter 3 41
- Removing the Cover 42
- Slimline 43
- Replacing the Cover 45
- Changing the Jumper Settings 49
- Setting the Jumpers 50
- Dins 1 and 2 51
- SIMM configurations 52
- Inserting SlMMs 54
- Removing SlMMs 55
- Installing an Option Card 57
- Removing an Option Card 63
- Adding Video Memory 63
- Upgrading the Processor 65
- Post-installation Procedures 67
- Chapter 4 68
- Connecting the Drive Cables 75
- IDE device 76
- Installing and 77
- Removing Slimline 79
- Slimline Drives 86
- IDE device connectors 96
- IDE device 97
- Tower Drives 99
- Chapter 6 114
- Identifying Your System 115
- TYPE C: \CONFIG.SYS and press 116
- TYPE C:\AUTOEXEC.BAT and 116
- The Computer Will Not Start 117
- The Computer Does Not Respond 118
- Keyboard Problems 119
- Mouse Problems 119
- Monitor Problems 120
- Diskette Problems 121
- Diskette Drive Problems 122
- Hard Disk Drive Problems 123
- CD-ROM Drive Problems 125
- Password Problems 125
- Software Problems 126
- Printer or Scanner Problems 127
- Option Card Problems 128
- Memory Module Problems 129
- External Cache Problems 129
- Controller Problems 130
- Appendix A 131
- Computer Specifications 132
- Controllers 133
- Diskette 134
- Interfaces 134
- Keyboard 134
- Mass Storage 135
- SETUP Program 136
- Power Supply 137
- Option Slot Power Limits 137
- Physical Characteristics 137
- System Memory Map 138
- Non-interlaced and interlaced 139
- Interlaced 139
- Hard Disk Drive Information 140
- DMA Assignments 141
- Hardware Interrupts 142
- System I/O Address Map 142
- Hex address 143
- Assigned device 143
- 080 - 09F 143
- DMA page register, 74LS612 143
- Connector Pin Assignments 144
- Options Available From EPSON 145
- Appendix B 146
- Running SETUP 147
- Using the System Setup Option 148
- System Setup options 149
- Defining your 151
- Memory cache options 154
- PC/ devices options 155
- Setting the Boot Options 156
- Boot sequence option settings 157
- Entering 159
- SETUP and Installing Drivers 160
- Setting the Green PC Options 161
- Green PC options (continued) 162
- Installing Video Drivers 165
- Glossary 166
- 2 Glossary 167
- Glossary 3 168
- 4 Glossary 169
- Glossary 5 170
- Parallel 172
- Glossary 7 172
- 8 Glossary 173
- 10 Index 183
Related products and manuals for PC/workstation barebones Epson ActionTower 8600
(7 pages)
(117 pages)© 2020, manymanuals.com. All rights reserved. | 2.141 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals