Epson Stylus Color IIs Specifications download pdf (Page 40)

Transporting the Printer

If you need to transport your printer, follow these steps:

1. Press the

Pause

button and turn off the printer.

2. Open the printer cover and make sure that the print head

is locked in the far right position. If it isn’t, turn on the

printer, wait about 10 seconds, and turn it off.

Caution:

Do not remove the ink cartridges when transporting the

printer. Transporting the printer without the cartridges

installed can damage the printer.

3. Unplug the power cord from the electrical outlet.

4. Disconnect the interface cable from the printer.

5. Remove any paper from the sheet feeder and remove the

paper support.

6. Push in the output tray extension and close the tray.

7. Install the transportation screw to secure the print head to

the carriage as described in the sticker above the print head.

8. Attach any other protective materials to the printer. See the

Notice Sheet that was packed with the printer.

9. Repack the printer and attachments in the original box.

Be sure to keep the printer flat as you transport it. If you notice

problems with your printed output after transporting the

printer, clean the print heads as described on page 3-2. If the

image is misaligned, calibrate the printer as described in your

Setup and Software Guide

or as described below, if you are

printing from DOS.

Maintenance

3-9

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 84 85

No comments

Epson Stylus Color IIs Specifications Page 40