Epson 7500 User Manual download pdf (Page 15)

Connecting a Monitor

The way you connect your monitor to the computer depends

on the type of monitor you have. If you have a VGA monitor

(or a multifrequency monitor with an analog connector), you

can connect it to the computer’s built-in VGA port as described

below. If you have any other type of monitor (or if you want to

install a display adapter card to control your monitor), see

Chapter 2 of the User’s

Guide.

Note

If a manual was provided with your monitor, refer to those

instructions along with the ones below.

Follow these steps to connect your VGA monitor to the built-in

VGA port on the computer:

Place your monitor on top of or near the computer. Turn the

monitor and computer around so the backs are facing you.

There should be two cables provided with your monitor: the

monitor cable (to connect it to the computer) and the power

cable (to connect it to a power source). On most monitors,

the monitor cable is permanently attached to the monitor,

as shown in the illustration on the next page. If your

monitor does not have an attached cable, connect the cable

to it now. (See your monitor manual for instructions.)

1-4

Setting Up Your System

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

No comments

Epson 7500 User Manual Page 15