Epson EMP-TW100 Installation Guide Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 68
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
8
Turning Off the Projector
Follow the procedure below to turn off the power of the projector.
Procedure
1
Turn off the power for the signal
sources that are connected to the
projector.
Check that the power for all connected
components has been tuned off.
2
Press the [Power] button on either the
remote control or the projector's
control panel.
The confirmation message shown at left will
appear.
If you do not want to turn off the power, press
any button except the [Power] button.
If you do not carry out any operation, the
message will disappear after seven seconds. (The
power will not turn off at this time.)
3
Press the [Power] button once more.
The lamp unit will turn off and the indicator
will flash orange as the cool-down
period
starts.
4
Check that the indicator has changed
to light orange.
When the indicator lights orange, cool-down is
complete.
The cool-down period lasts for approximately 2
minutes. (This varies depending on factors such
as the ambient air temperature.)
5
If not using the projector for long
periods of time, turn off the main power
switch at the rear of the projector.
The projector buttons cannot be operated
while the indicator is flashing orange.
Wait until it lights steadily.
Power OFF?
Please press key again
to power off.
Projector
Remote control
Lights orange
Do not turn off the main power switch at the rear of the projector while the cool-down
is in progress. If the main power switch is turned off before cool-down is complete,
wait for the lamp to cool down (normally about one hour is required) before turning
the power back on again. If the power is turned off and on before the lamp has
cooled down, it may result in lamp operating errors.
Refer to "Lamp operating error" on page 35.
Downloaded From projector-manual.com
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

Comments to this Manuals

No comments