Epson EMP-TW100 Installation Guide download pdf (Page 40)

When the Indicators Provide No Help

Condition

No images appear (Messages do appear)

“Not Suppored.” message appears on the screen.

“No-Signal.”message appear on the screen.

Probable cause Remedy

Does the input signal setting match the

connected source?

Use the “Video Signal”, “Input A” or “Input B”

commands in the “Advanced” menu to select the signal

format that matches the connected source.

“Advanced” - “Video Signal”, “Input A”, “Input B”

(p.29)

Has the correct image input port been

selected?

Press the [Source] button on the projector's control

panel (or the [D-RGB], [A], [B], [Video] or [S-Video]

button on the remote control) to change the image

source. (p.7)

Is the power for the computer or video source

turned on?

Turn on the power. (p.7)

Check the mode which corresponds to the

frequency of the image signals being output

from the computer.

Refer to the documentation provided with your

computer for details on changing the resolution and

frequency of the image signals being output from the

computer. (p.50)

If a laptop computer or a computer with a

LCD screen has been connected to the

projector, it is necessary to output the image

signals to the projector rather than to the

screen.

Normally image signals are output to only the

computer's LCD screen, so you need to change the

output to an external destination. For some computer

models, when the image signals are output externally,

they no longer appear on the LCD screen. For details,

refer to the section of the documentation provided with

your computer under a heading such as "External

output", "Connecting an external monitor" or similar.

(p.7)

Downloaded From projector-manual.com

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 67 68

Comments to this Manuals

No comments

Epson EMP-TW100 Installation Guide Page 40

Comments to this Manuals

Related products and manuals for Data projectors Epson EMP-TW100