Epson Ensemble HD 1080 Projector User's Guide download pdf (Page 37)

Note

The menus for the listed components remain blank until you enter the setup code for the component. The remote control

also has several other menus (DVD, RADIO, AUDIO, and PROJ). These are used to operate the built-in components of the

Ensemble HD system.

If you have a type of component not listed above, first enter its setup code as described in the next section. Then see

“Customizing the Remote Control Menu” on page 39 for additional instructions.

Entering the Setup Code for Your Component

You enable the remote control to recognize the new component by entering a setup code from the tables

starting on page 85. You may have to try out several codes before finding the right one for your component.

Once the correct code is entered, the remote control will automatically create the appropriate commands in the

menu for the new device.

If you can’t find the correct code, you can “teach” the remote control how to operate your new component one

function at a time, but this may take much longer (see page 72).

1 Turn on the component you want to set up. Each time you enter a code, the remote control will try to turn

off your component by sending a power-off command. You will know that you have entered the correct

code when the component turns off.

2 Press and hold both the

MAIN and ENT (Enter) buttons for approximately three seconds to enter the

SETUP menu.

Note

You have 30 seconds to perform a step while you are in the SETUP menu. If you don’t press a button, the remote

control returns to the MAIN menu.

3 Select the P-PRO (Pre-Programmed) option on the LCD screen.

MAIN button

ENT button

SETUP

P-PRO

LEARN

EDIT

MACRO

FAV

1 OF 3

Select P-PRO

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 131 132

No comments

Epson Ensemble HD 1080 Projector User's Guide Page 37