Epson Ensemble HD 1080 Projector User's Guide download pdf (Page 82)

Note

You have 30 seconds to complete each step. After that, the remote control returns to normal operation.

2 Select the RF option. You see this screen:

3 Select the setting you want to adjust:

•

IR/RF to cause the remote control to emit IR signals only, RF signals only, or IR and RF signals at the

same time. If a component receives IR signals directly from the remote control and from the base

station at the same time, the signals may interfere with each other, so you should set the remote

control to use only RF signals with that component. (You can select the component in step 4.)

•

ID # to select the receiver ID # of your addressable base station. Select an address other than 0 (zero) to

prevent interference from other RF remote controls in the vicinity.

•

EMITT to route commands through specific emitters plugged into the base station. (The ID # must be

set to a non-zero address to select this option.)

•

BLAST to turn the base station’s IR blaster on or off. You may want to turn it off if the blaster’s high-

power LED saturates or overpowers the sensors of some AV components. (The

ID # must be set to a

non-zero address to select this option.)

4 On the next screen, select whether you want the setting to apply to the menu options for all 10 devices

listed on the MAIN menu of the remote control (select

ALL) or just the ones for a specific device (select

DEVIC).

If you select

DEVIC (Device), the next screen lets you select the device you want the setting to apply to.

Select from

DVD, CABLE, SAT, etc. (Use the PAGE or button to display all the devices.)

5 On the next screen, finish adjusting the selected setting:

• For the IR/RF setting, select

IR&RF, IR, or RF.

• For the ID # setting, select

UP or DOWN to change the ID #.

• For the EMITT setting, select

ALL to route the signal through all the emitters. Or select UP or

DOWN to change the Line Output number (this refers to the jack where you plugged in the emitter

for a specific component).

• For the BLAST setting, select

ON or OFF.

6 Select

SAVE to save your setting.

7 Select

EXIT to return to the SETUP menu, or press the MAIN button twice to return to normal operation.

IR/RF

EMITT

BLAST

EXIT

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 131 132

Comments to this Manuals

No comments

Epson Ensemble HD 1080 Projector User's Guide Page 82

Comments to this Manuals

Related products and manuals for Data projectors Epson Ensemble HD 1080 Projector