Epson LQ-670 Troubleshooting Guide download pdf (Page 13)

EPSON LQ-670

3/97

EPSON LQ-0670 - 13

Positioning your continuous paper supply

When you load continuous paper, make sure you align your

paper supply with the tractor so the paper feeds smoothly into

the printer, as shown below.

Loading continuous paper with the tractor

1. Make sure the printer is turned off. Set the paper release

lever to the tractor position, as shown below. Also make sure

the paper thickness lever is set to “0” if you are using

ordinary continuous paper.

2. Slide the edge guides as far apart as they go.

3. Release the sprocket lock levers by pushing them up.

4. Facing the back of the printer, position the left sprocket unit

so that the sprocket pins are to the left of the “0” on the scale

and the arrow mark on the printer. Then push down the

lock lever to lock the sprocket in place.

Note:

Printing starts at the arrow mark on the printer and the

“0” mark on the scale. The unprintable area is to the left

of the arrow mark and the “0”.

5. Slide the right sprocket unit to roughly match the width of

your paper, but do not lock it.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

No comments

Epson LQ-670 Troubleshooting Guide Page 13