Removing and Replacing Subassemblies
Replacing the System Board
Follow these steps to replace the system board:
1
From the left side of the chassis, insert the system board into the chassis at a slight
angle.
2
Slide the far edge of the system board under the drive bay.
3
Lower the board into the chassis and position the six screw holes over the mounting
holes in the chassis.
4
Secure the board with the six retaining screws (see Figure 3-17).
5
Reinstall the option card riser board (see page 3-8) and replace any option cards (see
page 3-7).
6
Reconnect all cables and replace the cover.
Removing the Front Bezel
Follow these steps to remove the front bezel:
1
Remove the cover (see page 3-2).
2
Remove the two retaining screws located on the back side of the bezel as shown in
Figure 3-18.
Figure 3-18 Removing/Replacing the Front Bezel
3
Set the cover upside down on a smooth flat surface and locating the front bezel
locking tabs gently press down on the tabs while pulling the bezel away from the
cover.
Epson
NX
Service
Manual
3-23
Comments to this Manuals