Epson TM-T70 Instruction Manual download pdf (Page 37)

Rev. A Setup 2-15

TM-T70 Technical Reference Guide

3. Insert the connector of the power supply cable onto the power supply connector (labeled

DC24V).

Figure 2-21 Connecting the power supply

CAUTION:

Be sure to remove the power supply unit’s cable from the wall socket whenever

connecting or disconnecting the power supply unit to the printer. Failure to do so may

result in damage to the power supply unit or the printer.

Make sure the wall socket power supply satisfies the rated voltage requirements of the

power supply unit. Never insert the power supply cable plug into a socket that does not

meet the rated voltage requirements of the power supply unit. Doing so may result in

damage to both the power supply unit and the printer.

Note:

Before removing the DC cable connector from the EPSON PS-180 (current model power supply), make

sure the power supply cable has been removed from the power supply unit, then grasp the arrow-marked

section of the connector and pull straight out.

2.4.2 Connecting the Drawer Kick-out Cable

WARNING:

Prepare a drawer that meets printer specifications. Otherwise, the drawer kick-out

solenoid or other parts in the drawer might burn and cause a fire. This may also cause

the printer to malfunction at the same time.

Do not insert a telephone line into the drawer kick-out connector. Doing so may

damage the telephone line or printer.

24V

FG FG

Power supply

connector

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 83 84

No comments

Epson TM-T70 Instruction Manual Page 37