Epson Stylus Color 900 Ink Jet Printer User Manual download pdf (Page 15)

1-2

Installing EPSON Stylus RIP for Macintosh

Checking the Printer

Before you install the EPSON Stylus RIP software, follow the

instructions in your printers setup guide and users guide to

prepare your printer for use. Make sure you perform the

following steps:

◗

If youll be using the printer in a typical network

configuration (described in the following section), install an

optional network interface card in the printer. (Not every

printer has a network interface card option.) See your

printers users guide for instructions.

◗

Load paper, install ink cartridges, and allow your printer to

complete its entire ink charging cycle.

◗

Run a printer self test to make sure it operates properly.

◗

Connect the printer directly to your Macintosh or to the

network.

◗

Install the standard non-PostScript EPSON driver and

utilities that came with your printer.

◗

Send a sample print job with the standard printer driver to

make sure the interface connection and cable are secure and

the software is installed correctly.

Once the printer is set up and tested fully, youre ready to

install the EPSON Stylus RIP software on your system.

Nflight.bk Page 2 Thursday, April 22, 1999 5:02 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 78 79

No comments

Epson Stylus Color 900 Ink Jet Printer User Manual Page 15