Epson AcuLaser CX37DNF Guide User's Guide download pdf (Page 146)

6. Press the u or d key to select the size of the document positioned in step 5, and then press the

Select key.

7. After all document pages have been scanned, press the Start key.

The scanned document is sent to the specified location.

Note:

❏ If the Stop/Reset key is pressed while scanning, JOB CANCEL appears. To continue scanning,

select NO. To stop scanning, select YES.

❏ To cancel a job where scanning was finished and the data is queued to be sent, refer to “Deleting a

Queued Transmission Job” on page 165.

Specifying the Data Location

Select whether the computer or USB memory device is the location where scan data is to be saved.

When transmitting via a network, refer to “Specifying the Destination Address (Scan to E-mail/FTP/

SMB)” on page 147.

Note:

If an address has been specified as the destination for the data, SCAN TO USB MEMORY cannot be

selected.

Saving Data on a USB Memory Device (Scan to USB Memory)

Follow the procedure described below to save scan data to a USB memory device plugged into the USB

HOST port of this machine.

Note:

This machine is compatible with a USB memory device of 4 GB or less.

1. Plug the USB memory device into the USB HOST port of this machine.

2. In the main screen (Scan mode), press the u or d key to select SCAN TO, and then press the Select

key.

3. Press the u or d key to select SCAN TO USB MEMORY, and then press the Select key.

Note:

Depending on the USB memory device that is used, it may take some time for the scan data to be

transferred.

Epson AcuLaser CX37 Series Printer/Copier/Scanner User’s Guide

Using the Scanner 146

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 260 261

No comments

Epson AcuLaser CX37DNF Guide User's Guide Page 146