Epson ELPLP29 User Manual download pdf (Page 58)

Appendices > Projector Care

f Lamp replacement period

• It is time to change the lamp when the "Replace Lamp" message appears

in the bottom left hand corner of the screen at the commencement of

projection and remains for 30 seconds.

• It is also time to change the lamp when the Warning indicator flashes red

at 0.5 second intervals.

f Replacing the lamp

Turn off the projector and wait for the cool-down

period to end. (Approx. 20 seconds)

Remove the power cable and wait for the lamp to cool down. (Approx.

1 hour)

Open the lamp cover.

Lift the lamp cover by putting your fingers in the latches and lifting

upwards.

• The replacement message will appear after about 1900 hours of

use.

• When this message is displayed, please replace the lamp as

quickly as possible.

• The lamp may explode if you continue to use it beyond the

lamp replacement period.

• Some lamps may stop operating before the replacement

message is displayed. It is recommended that you have a

replacement lamp ready in case this happens.

• Replacement lamps can be purchased at your nearest dealer.

• Wait until the lamp has cooled down sufficiently before

opening the lamp cover. It takes a further one hour after the

cool-down period has finished for the lamp to be cool enough.

• When the lamp is broken, replace it with a new lamp, or contact

your dealer for further advice. If replacing the lamp yourself,

be careful to avoid pieces of broken glass.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 74 75

No comments

Epson ELPLP29 User Manual Page 58