Epson EMP-8300 User's Guide download pdf (Page 24)

24 Setting Up the Projector

Connecting to the BNC Port

1. Depending on your computer’s connection, obtain the correct

type of BNC cable (these cables are commercially available):

■ If your computer has a VGA port, use a VGA–5BNC cable.

■ If your computer provides video output through BNC

connectors, use a 5BNC–5BNC cable.

2. Connect the cable to the projector’s

BNC port as shown. Connect

the red, green, and blue connectors to the corresponding

R, G,

and

B ports on the projector. Then plug the remaining two

connectors into the corresponding H/C Sync and V Sync ports.

3. Connect the other end to your computer’s video-out or monitor

port.

4. Optionally, you can connect an external monitor (see page 28),

play sound through the projector (see page 29), or connect a USB

cable to use the remote control as a mouse (see page 27).

5. If you don’t need to make any other connections, see Chapter 2

for instructions on turning on the projector and adjusting the

image. Once the projector is turned on, be sure to:

■ Enter the projector’s Setting menu, then make sure the BNC

Input is set to

Analog-RGB (this is the default setting; see

page 70).

■ After exiting the menu system, select BNC as the source to see

your image (see page 34).

note

The connectors on your cable

may be labelled, or they may

be color-coded (black for

H/C Sync and gray for

VSync).

RGB

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 135 136

No comments

Epson EMP-8300 User's Guide Page 24