108 Using the Projector on a Network
Using the Tools Tab
Select the Tools tab in the top right corner of the window to display
the window shown below:
1. Enter settings for Crestron
®
central controllers in the Crestron
Control
section of the window.
2. Enter settings in the
Projector section of the window:
■ Enter a Projector Name to differentiate the current
projector from other projectors on the network (up to 15
single-byte alphanumeric characters).
■ Enter a Location name for the projector (up to 32 single-byte
alphanumeric characters).
■ Enter a user name for the projector in the Assigned To box
(up to 32 single-byte alphanumeric characters).
■ Click the Enabled checkbox to use DHCP.
■ If you’re not using DHCP, enter an IP Address for the
projector.
■ Enter a Subnet Mask and Default Gateway address for the
projector.
3. Click
Send to register the changes you made in the Projector
section of the window.
Comments to this Manuals