Epson S1D13705 User Manual download pdf (Page 460)

Page 8 Epson Research and Development

Vancouver Design Center

S1D13705 Interfacing to the Motorola MPC821 Microprocessor

X27A-G-010-02 Issue Date: 01/02/13

2 Interfacing to the MPC821

2.1 The MPC8xx System Bus

The MPC8xx family of processors feature a high-speed synchronous system bus typical of

modern RISC microprocessors. This section provides an overview of the operation of the

CPU bus in order to establish interface requirements.

2.2 MPC821 Bus Overview

The MPC8xx microprocessor family uses a synchronous address and data bus. All IO is

synchronous to a square-wave reference clock called MCLK (Master Clock). This clock

runs at the machine cycle speed of the CPU core (typically 25 to 50 MHz). Most outputs

from the processor change state on the rising edge of this clock. Similarly, most inputs to

the processor are sampled on the rising edge.

Note

The external bus can run at one-half the CPU core speed using the clock control register.

This is typically used when the CPU core is operated above 50 MHz.

The MPC821 can generate up to eight independent chip select outputs, each of which may

be controlled by one of two types of timing generators: the General Purpose Chip Select

Module (GPCM) or the User-Programmable Machine (UPM). Examples are given using

the GPCM.

It should be noted that all Power PC microprocessors, including the MPC8xx family, use

bit notation opposite from the convention used by most other microprocessor systems. Bit

numbering for the MPC8xx always starts with zero as the most significant bit, and incre-

ments in value to the least-significant bit. For example, the most significant bits of the

address bus and data bus are A0 and D0, while the least significant bits are A31 and D31.

The MPC8xx uses both a 32-bit address and data bus. A parity bit is supported for each of

the four byte lanes on the data bus. Parity checking is done when data is read from external

memory or peripherals, and generated by the MPC8xx bus controller on write cycles. All

IO accesses are memory-mapped meaning there is no separate IO space in the Power PC

architecture.

Support is provided for both on-chip (DMA controllers) and off-chip (other processors and

peripheral controllers) bus masters. For further information on this topic, refer to Section

6, “References” on page 23.

The bus can support both normal and burst cycles. Burst memory cycles are used to fill

on-chip cache memory, and for certain on-chip DMA operations. Normal cycles are used

for all other data transfers.

1 2 ... 455 456 457 458 459 460 461 462 463 464 465 ... 561 562

No comments

Epson S1D13705 User Manual Page 460