Epson TM-T70 Instruction Manual download pdf (Page 28)

2-6 Setup Rev. A

Note:

* Factory setting

DIP SW2-1: For details on the BUSY condition, also refer to

“Busy State” (page 3-10)

Note:

Do not change DIP switch settings 2-2 and 2-6. Doing so may cause the printer to malfunction.

Note:

• Turn off the power before changing the DIP switch settings.

• DIP switch settings are enabled only when the power is turned on or the printer is reset via the

interface. If the settings are changed after that, the functions will not change.

• If the print density is set to More dark than standard or More dark, printing speed may slow down.

Table 2-6 Parallel/USB/Ethernet/Wireless LAN DIP switch bank 1

SW Function ON OFF DEFAULT

1-1 Automatic line feed Enabled at all times Disabled at all times * OFF

1-2 Receive buffer size 45 bytes 4KB * OFF

1-3 Reserved (Always use printer with these

switches set to OFF.)

—— OFF

1-4 Error signal output Disabled Enabled OFF

1-5 ~

1-8

Reserved (Always use printer with these

switches set to OFF.)

—— *OFF

Table 2-7 Parallel/USB/Ethernet/Wireless LAN DIP switch bank 2

SW Function ON OFF DEFAULT

2-1 Handshake (BUSY conditions)

• Receive buffer full • Offline *

• Receive buffer full

OFF

2-2 Reserved (do not change setting) Fixed to OFF OFF

2-3, 2-4 Print density selection/low-power mode (See separate table.) OFF

2-5 Reserved (Always use printer with these

switches set to OFF.)

—— OFF

2-6, 2-7 Reserved (do not change setting) Fixed to OFF OFF

2-8 Pin #31reset signal (do not change setting) Fixed to ON ON

Table 2-8 Selection of print density

Print density

Switch No.

2-3 2-4

Print density Low power consumption mode ON ON

Print density Standard* OFF OFF

Print density More dark than standard ON OFF

Print density More dark OFF ON

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 83 84

Comments to this Manuals

No comments

Epson TM-T70 Instruction Manual Page 28

Comments to this Manuals

Related products and manuals for POS/mobile printers Epson TM-T70