Epson 2000P User Manual download pdf (Page 39)

After you finish your printout, you can leave the paper in place and start another print

job immediately after it. If you wish to make a dividing line between print jobs, press

the

E load/eject button. The printer prints a small line on the roll paper to show you

where to cut it and feeds the paper forward. Press the

E load/eject button again; the

paper automatically moves back into the correct position before printing.

If you’re done printing, follow the steps in the next section to remove and store the

roll paper.

Removing and Storing Roll Paper

After you finish printing, you need to cut off your printout from the rest of the roll

and remove the roll paper from the printer. Follow these steps:

1. Press the

E load/eject button. The printer

prints a small line on the roll paper to show

you where to cut it and feeds the paper

forward.

2. Cut the roll paper, using the line as a guide.

3. If you want to continue printing on the roll paper, press the

E load/eject button

again; the paper automatically moves back into the correct position before

printing.

If you’ve finished printing on the roll paper, hold down the

E load/eject button

for about three seconds. The roll paper feeds backward so you can remove it from

the printer. (You may need to repeat this step to back it all the way out.)

After you finish printing, remove the roll paper from the printer and return the

unused paper to its original package. Store or display your printouts by following the

guidelines in “Taking Care of Your Prints” on page 25. Keep unused paper, as well as

your printouts, away from high temperatures and humidity and out of direct sunlight.

Load/eject button

Don’t cut inside the line closer to

the printer.

Don’t pull on the paper as you cut it;

you may damage your printout.

Pbasics.book Page 34 Wednesday, November 29, 2000 5:46 AM

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 76 77

No comments

Epson 2000P User Manual Page 39