Epson Aculaser C9200N User's Guide download pdf (Page 196)

Cause What to do

The electrical outlet may be controlled by an outside

switch or an automatic timer.

Make sure that the switch is turned on or plug another electrical

device into the outlet to check whether the outlet is operating

properly.

The printer does not print (Ready light off)

Cause What to do

The printer is offline.

Press the Start/Stop button once to switch the printer to ready

status.

Some error may have occurred. Check the LCD panel to see if an error message appears.

The Ready light is on but nothing prints

Cause What to do

Your computer may not be properly connected to the

printer.

Perform the procedure illustrated in the Setup Guide.

The interface cable may not be plugged in securely. Check both ends of the interface cable between the printer and

the computer.

You may not be using the correct interface cable. If you are using the parallel interface, make sure that the cable is

a double-shielded, twisted-pair interface cable no more than six

feet in length.

If you are using the USB interface, use a Revision 2.0 cable.

Your application software is not properly set up for your

printer.

Make sure that the printer is selected in your application software.

Your computer system’s memory is too small to handle

the volume of data in your document.

Try reducing the image resolution of your document in the

application software, or install more memory in your computer if

you can.

The optional product is not available

Cause What to do

The printer does not recognize the optional product. Print a configuration status sheet to see if the printer recognizes

the optional product. If not, reinstall the optional product.

EPSON AcuLaser C9200 Series User's Guide

Troubleshooting 196

Downloaded from ManualsPrinter.com Manuals

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 270 271

No comments

Epson Aculaser C9200N User's Guide Page 196