Epson AcuLaser C9300 User Manual download pdf (Page 164)

Cause What to do

One of the toner cartridges may be near the end of its

service life.

If the message on the LCD panel or in EPSON Status Monitor

indicates that one of the toner cartridges is near the end of its

service life, open cover D, make sure the cartridge is locked, and

tap the top of the toner cartridge about five times with your finger.

If the problem is not resolved, replace the toner cartridge. See

“Replacing Consumable Products” on page 133.

For Windows users, you can also check the remaining service life

of the toner cartridge by looking at the Basic Settings tab in the

printer driver.

There may be a problem with photoconductor units. Replace the photoconductor units. See “Replacing Consumable

Products” on page 133.

The non-printed side of the page is dirty

Cause What to do

Toner may have spilled onto the paper feed path. Clean internal printer components by printing three pages with

only one character per page.

Print quality decreased

Cause What to do

The printer cannot print in the required quality level

because of insufficient memory, and the printer lowers

the quality automatically so that the printer can continue

printing.

Check to see if the printout is acceptable. If not, add more memory

for a permanent solution or lower print quality temporarily in the

printer driver.

If RAM Disk is set to Maximum or Normal on the control panel, you

can increase the available memory space by changing this setting

to Off.

Epson AcuLaser C9300 Series User's Guide

Troubleshooting 164

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 209 210

No comments

Epson AcuLaser C9300 User Manual Page 164