Epson 5600p User Manual download pdf (Page 33)

Using the Projector

Adjusting the Height of Your Image

If the image is too low, you can raise it by extending the projector’s

feet.

1. Stand behind the projector. Pull up the blue foot release levers

and lift the front of the projector. This unlocks the feet.

2. Once the image is positioned where you want it, release the levers

to lock the feet in position.

3. To fine-tune the height of the image, rotate the thumb wheels

attached to the projector’s feet.

If the image is no longer square after raising it, see the next section.

Adjusting the Image Shape

If the projected image isn’t square or has a “keystone” shape, do one or

more of the following:

■

If your image looks like or , you’ve placed the

projector off to one side of the screen, at an angle. Move it directly

in front of the center of the screen, facing the screen squarely.

■

If your image looks like or , press the

—

side of

the

Keystone

button to correct the shape of the image. After

correction, your image will be slightly smaller.

You can also perform electronic keystone correction using the

projector’s Setting menu. See page 53.

caution

Do not hold the projector by

the lens; this can damage it.

Keystone

5600 and 7600.book Page 27 Thursday, December 14, 2000 2:46 PM

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 113 114

No comments

Epson 5600p User Manual Page 33