Epson 5600p User Manual Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 114
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
30
Using the Projector
Shutting Down the Projector
When youve finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. If youve connected a computer or laptop and its displaying only
through the projector (the computers monitor is disconnected or
turned off), shut down the computer first; otherwise you may not
be able to see your computers display to shut it down properly.
2. To turn off the projector, press the red
Power
button on the
projector or remote control. You see a confirmation message. (If
you dont want to turn it off, press any other button.)
3. Press the
Power
button again. The power light flashes orange for
about a minute as the projector cools down. When the projector
has cooled, the orange light stays on and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the
Power
button.
4. Replace the lens cap and unplug the power cord.
5. If youre using a VCR or other video source, turn it off after you
turn off the projector.
6. Disconnect all equipment, and store the projector in a protective
case.
note
When the projector has not
received any input signals for
3
0 minutes, it automatically
turns off the projector lamp
and enters sleep mode. This
conserves electricity, cools the
p
rojector, and extends the life
of the lamp. If you are done
using the projector, unplug
the power cord. If you want
to start projecting again, press
the
Power
button.
Power
Power button
power light
caution
To avoid damaging the
p
rojector or lamp, never
unplug the power cord when
the power light is green or
f
lashing orange.
5600 and 7600.book Page 30 Thursday, December 14, 2000 2:46 PM
Page view 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 113 114

Comments to this Manuals

No comments