EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-110
4.3.1 Cover Assembly Exit,E
1. Remove the Cover Side, E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E. (Section 4.2.4)
4. Remove the Tray Assembly MBF.E. (Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Set the Cover Assembly,E on its rear surface.
7. Remove the three screws that secure the Bracket Hin
e,E to the
Cover Assembly,E.
8. Carefully manipulate the Cover Exit,E to move the Bracket Hin
e
away from the mount toward you and then raise the ri
ht side of the
Cover Exit to tilt the Cover Exit (1).
9. Shift the Cover Exit to the ri
ht to
et the pivot on the left arm out of
the pivot hole on the left side of the Cover Main (2).
10. Take the Cover Exit out of the Cover Assembly,E (3).
Figure 4-7. “Cover Assembly Exit,E” Removal
CHECK
PO INT
Be careful not to damage the strip conductor laid by
the Bracket Hinge.
Comments to this Manuals