Epson C82363 Specifications Page 117

  • Download
  • Add to my manuals
  • Print
  • Page
    / 210
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 116
EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-119
4.3.10 Actuators Pre-Registration A and B
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Lever Jam Clear, Sprin
g
-Hold Rod, Stopper Rod and
Sprin
g
Nip Pre-Re
g
istration (steps 6 and 7 of PL4.1.1).
7. Remove the Frame Assembly MBF.(Section 4.3.19)
8. Remove the C258MAIN Board.(Section 4.3.49)
9. Remove the Shield Assembly Bottom (E).(Section 4.3.44)
10. Remove the PWBA Hotaru.(Section 4.3.48)
11. Remove the Chassis Assembly PS.(Section 4.3.46)
12. Remove the Roll Assembly Feed.(Section 4.3.7)
13. Remove the Actuator No Paper.(Section 4.3.8)
14. Remove the Drive Assembly-F/P.(Section 4.3.42)
15. Remove the Drive Assembly Main.(Section 4.3.43)
16. Remove the Drive Assembly.(Section 4.3.3)
17. Remove the Sensor Toner if installed.
18. Remove the Kit Chute Re
g
istration Assembly. (Section 4.3.11)
19. Pull the ri
g
ht end (sprin
g
-loaded end) of Actuator Pre-Re
g
istration B
(PL3.1.19: one with the lon
g
er shaft) out of the retainin
g
openin
g
in
the ri
g
ht mountin
g
post, and slide the Actuator off of the hole in the
left mountin
g
post.
20. Pull the Actuator Pre-Re
g
istration A out of the retainin
g
openin
g
in
the mountin
g
posts.
Figure 4-16. “Actuator Pre-Registration A” Removal
Page view 116
1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 209 210

Comments to this Manuals

No comments