EPSON EPL-N1600 Chapter 3 Troubleshooting
Rev. A 91
3.8 WHITE SPOT
Problem Suspect Components
There are areas of the ima
e that
are extrreaml
li
ht or missi
entirel
. These missin
areas
form spots that are localized to
small area of the pa
e
The followin
components are assosiated with
this specific problem. One or more of these
components ma
have failed partiall
or
completel
. If
ou can not isolate the problem
usin
this procedure, replace each components
listed below, one at a time, until the problem
disappears.
• Roll BTR
• Fuser Ass
.
•Ima
in
Cartrid
e
Step Action and Question Yes No
1 PAPER CONDITIONS
• Is the paper damp?
• Is the paper wrinkled?
Replace with a
new, dr
paper.
Go to Step 2.
2 IMAGING CARTRIDGE
Install a new Ima
in
Cartrid
e.
Is the print ima
e normal?
Problem solved. Go to Step 3.
3 ROLL BTR
Inspect the Roll BTR for
contamination and wear.
Is the Roll BTR free of contamination
and wear?
Go to Step 4. Replace the
Roll Ass
. BTR.
4 ROLL FUSER AND ROLL PRESS
1. Remove the Fuser Ass
.
2. Inspect the Roll Fuser and the Roll
Press for scratches and
contamination.
Are these Rolls free of scratches and
contamination?
Go to suspect
component.
Replace the
Roll Fuser or
the Roll Press.
Comments to this Manuals