Epson TM-T70 Instruction Manual download pdf (Page 35)

Rev. A Setup 2-13

TM-T70 Technical Reference Guide

2.3.4.2 Connecting the Ethernet Interface Cable

1. Make sure the power supplies for both the printer and host computer have been turned off.

2. For 10BASE-T/100BASE-T Ethernet, connect a 10BASE-T/100BASE-T cable to the 10BASE-

T/100BASE-T Ethernet connector by pressing firmly until the connector clicks into place.

Figure 2-20 Example Ethernet port interface panel (UB-E02)

CAUTION:

Connecting devices directly to LAN cables installed outdoors exposes them to damage

from power surges caused by lightning and other inductive sources. Make sure devices

without proper surge protection are cushioned by being connected through devices

that do have surge protection. Otherwise, do not connect them to outdoor lines.

Never attempt to connect the customer display cable, drawer kick-out cable, or the

standard telephone line cable to the 10BASE-T/100BASE-TX Ethernet connector.

Note:

To use the Ethernet interface, the separate IP Address Setup Utility for the UB-E02 is required. For

details on the various setup methods, refer to “UB-E02 Technical Reference Guide.” You can obtain

the “IP Address Setup Utility for UB-E02” and the “UB-E02 Technical Reference Guide” from one of

the following URLs:

For customers from North America, go to the following web site:

http://pos.epson.com/

For customers from other countries, go to the following web site:

http://www.epson-pos.com/

Select the product name from the “Select any product” pull-down menu.

Other compatible Ethernet interface modules may be available for your printer. Contact your EPSON

dealer for information on the options available.

10BASE-T/100BASE-T Ethernet

interface connector

LED (green)

LED (yellow)

Switch

Drawer kick-out

connector

Printer power supply

connector

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 83 84

No comments

Epson TM-T70 Instruction Manual Page 35