Epson TM-T70 Instruction Manual download pdf (Page 7)

Rev. A v

TM-T70 Technical Reference Guide

Conditions of Acceptability

1. The supply source shall be SELV and non-hazardous energy level (less than 240VA).

2. When this product is installed in the product which has a total mass not exceeding 18kg, the

enclosure of this product were evaluated as a fire enclosure.

3. The interface connectors except for input connector shall be described in installation or

safety instruction to identify Non-LPS at end product.

WARNING:

The connection of a non-shielded printer interface cable to this printer will invalidate the

EMC standards of this device. You are cautioned that changes or modifications not

expressly approved by Seiko Epson Corporation could void your authority to operate

the equipment.

The interface connectors are supplied from Non-LPS.

CE Marking

The printer conforms to the following Directives and Norms:

Directive 89/336/EEC EN 55022 Class B

EN 55024

IEC 61000-4-2

IEC 61000-4-3

IEC 61000-4-4

IEC 61000-4-5

IEC 61000-4-6

IEC 61000-4-11

FCC Compliance Statement For American Users

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instruction manual, may cause harmful interference to radio

communications.

Operation of this equipment in a residential area is likely to cause harmful interference, in which

case the user will be required to correct the interference at his own expense.

For Canadian Users

This Class A digital apparatus complies with Canadian ICES-003.

1 2 3 4 5 6 7 8 9 10 11 12 ... 83 84

No comments

Epson TM-T70 Instruction Manual Page 7